where to get saws serviced/repaired in east sussex/kent.

[sussexlad]

hi guys wondering if any of you down this end of the country have any fairly cheap and reliable places that you get your saws repaired at? im not really keen on going to culverwells or harper and theives and getting my pants pulled down!

cheers!

[Pedroski]

I can tell you where not to go. Work mate took a saw that kept cutting out to one particular place. Picked it up weeks later after being told again and again that it wasn't ready yet. The firm billed for him for new carb (not carb kit, but complete carb) + labour, and told him it was all fine. Anyway, took it away, started it, and exactly the same - cutting out. Called the firm up and the fella tried to say it had been started after being repaired and was working perfectly. So mate poked around....noticed a small pipe disconnected, reconnected it and it was perfect. The problem all along was caused by one little pipe being off, that if the repairer had genuinely replaced the carb then he would have spotted. So don't go there.

 

If you want someone reliable then you could go to AMP in Hallyburton Road, Hove, tel 01273 418918. They're really easy to get to - about 5 mins from the A27.

[Gollum]

Lamberhurst Engineering 01892 890 364 Good and reliable

[sussexlad]

thanks for the replies gents.

 

id forgotten about lamberhurst engineering so will probably go there,its only 15 mins from me.

 

cheers!

[mike lidster]

another place for repairs and service is LISTON PRODUCTS at new haven 01273 510521 easy to find on the avis way estate.