Large oak in search of mill

[usmc0602]

Looking to sell some oak either 'as is' or milled to order at a specific size. You could mill it onsite (noise and mess don't matter) or take it away. It is accessible from the end of my driveway but the lane is not large.

 

It had to be cut into 3 lengths to get it up a hill and into my side garden.

Measurements are roughly:

Log 1 - 17ft long and 80 cu ft

Log 2 - 15ft long and 90 cu ft

Log 3 - 8.5ft long and 15 cu ft

 

Located in south Wales (NP8 post code). Please let me know if you would like any other measurements, pictures, etc.

Below is a cross-section from the middle log which is 37" at the widest.

Thanks.

 

 

 

Edited November 15, 2018 by usmc0602
clarified it was for sale

[topchippyles]

What finished sizes do you want it cut to.

[usmc0602]

Good question. I should have been clearer in my original post (now updated) that the oak is for sale either 'as is' or milled to order at a specific size.

[topchippyles]

I have a bandsaw mill and am based up on the heads of the valleys and can mobile mill with my chainsaw mill,I get a lot of stuff down your way to.

Edited November 15, 2018 by topchippyles

[kerryp]

Topchippyles if you don't mind me asking what would be your going rate for the day got a nice big oak in Carmarthen that could do with cutting into planks 

[topchippyles]

Will be after christmas now as busy with a few projects over the next few weeks,Days milling is around £300 plus fuel

[Old Lands]

On 20/11/2018 at 20:51, kerryp said:

Topchippyles if you don't mind me asking what would be your going rate for the day got a nice big oak in Carmarthen that could do with cutting into planks 

kerryp what size is your oak and does it still need cutting?

 

I have a Peterson WPF and can get to Carmarthen easily enough.