Frontier 5L bar needed

[shavey]

This link below will sort your problems out 

 

https://www.ebay.co.uk/itm/Vintage-Danarm-Petrol-Chainsaw-/173572702778

[Guineafowl]

Shavey - that bar wouldn’t do as the oil hole’s in the wrong place. The old bar had a closed end.

 

I’ve found an Archer 20A0-RN-MA bar and chain that might fit. Seller is going to post some better pics of the mount.

 

I saw that Danarm, and was tempted, but the lazy bugger won’t post. 

[shavey]

26 minutes ago, Guineafowl said:

Shavey - that bar wouldn’t do as the oil hole’s in the wrong place. The old bar had a closed end.

 

I’ve found an Archer 20A0-RN-MA bar and chain that might fit. Seller is going to post some better pics of the mount.

 

I saw that Danarm, and was tempted, but the lazy bugger won’t post. 

That’s a shame he wouldn’t post it’s cheap enough

 

that bar In the photo is d276 Mount 

[Guineafowl]

7 minutes ago, shavey said:

that bar In the photo is d276 Mount

This is the problem - look at the collectors’ corner one http://www.acresinternet.com/cscc.nsf/14711d8004b6ea7c88256e0c0001ff32/0dbf85f6a2a9a7c988256e0e001f792a?OpenDocument

 

THAT one would fit, and it’s called a D276.

[Guineafowl]

 

This is the exact mount I need. 

[shavey]

I gotta frontier bar in a job lot of spares I bought this week if your other purchase didn’t work out

[Guineafowl]

31 minutes ago, shavey said:

I gotta frontier bar in a job lot of spares I bought this week if your other purchase didn’t work out

Aha! The other guy still hasn’t got back to me, and he’s over in the US so it was always a bit unlikely.

 

Have you got a pic/numbers?

[shavey]

Iam afraid it’s only 16” though but here are some photos

[Guineafowl]

Thanks Shavey. That bar would look perfect on the saw, but I think the oil hole’s too high. Here’s the bar mount again:

 

 

And the bar fragment on the saw. The elongated hole is for oil. Here, only the bottom half overlaps the oil channel. 

 

 

You’d think a Frontier bar would fit a Frontier saw, wouldn’t you?!

[Guineafowl]

While looking for a bar for this saw I’ve somehow managed to buy a McCulloch Pro-Mac 10-10.

 

The bar from this one (Oregon 23226) will fit right on the Frontier.

 

However, the Mac is in good nick and is worth using, but it’s missing the two side plates that clamp the bar. Oil pees out when it’s running. Would anyone on here have some spares?