greenmech 130 problem

[beech tree]

Hi guys,

Any help would be appreciated, I own a Greenmech Arborist 130, Honda petrol engine, I washed the chipper last sunday and haven't used the machine for a week, due to hiring in a tracked machine for jobs. Today I used it, it started up fine, but rollers wouldn't engage, after a few minutes they worked fine for 10 minutes then stopped. Knew I have no display on the RDS unit and the rollers don't work at all. Engine starts and stops fine just wont allow rollers to operate.

Many thanks for your help

[jackrs1]

If you message jase hutch I’m sure he would be able to help you[emoji1303]

[beech tree]

Sorry for the delay in replying, thank you very much for your help mate much appreciated 

[jackrs1]

No problem mate

[GA Groundcare]

Hi,

 

remove the panel on the machine that covers the battery and feed rollers. Under there will be a couple of large round connector blocks in the main wiring harness. You have probably got water inside these. Unscrew the connectors, blow them out, pop a bit of Vaseline in there, make sure the O ring seals are present and in good condition and re assemble.

 

This will most likely fix your problem. Any issues give me a call on 07881 027599 and I can talk you through anything else.

Ash

Edited February 28, 2018 by GA Groundcare

[Wentworth arborist]

It’s the relay in side panal iav just had same problem last week