liampud

thanks for the helpful replies men, some idiot measured the bar wrong:blushing: and have been searching for the wrong chain, it is 15" and I now have one fitted, teeth look abit more aggressive than my old one but that could of just been wore right down even know it was still cutting good someone hit the ground a few times, i'll see how I get on with it tomorrow, its a husky chain and has '25' stamped on the teeth as did the old dolmar chain, so should be ok, unless that is the norm for a .325 1.3 .050 chain, cheers, Liam,

i measured the bar again this morning and it is cos to 15 than it is to 16" so have ordered a 15" oregan chain. it doesnt have on the bar what length it actually is either, cheers.

i have used the custom drop down and a chain the my saw is only £11, not sure about delivery though. on my bar it has;325-64 1.3/ .050 414-038 141 surely if all the numbers match up and it has 64 drive links it should fit, so i'm wondering if it is a 15" and i have measuered it wrong.

seen lots of 15" with the correct gauge and pitch that I need, I wonder if I have measured the bar wrong, does anyone know if the ps-410 dolmar is 15 or 16"? cheers

can anyone tell me if the chain in the link below will fit my 16" dolmar ps-410? the gauge and pitch are all the same but it doesn't say anywhere that it is 16", cheers, Liam. OREGON TYPE 20 chainsaw chain 64 DRIVE LINKS .325" pitch 0.50" gauge 20LPX CHAIN | eBay

i'll give them a ring on Monday, thanks again, Liam.

Thanks mate, the one in the link has 66 links, would this still work as long as the length, gauge and pitch were the same,

just looed and has a few numbers on, they are as follows: 325-64 1.3/ .050 414-038 141 any one know the correct chain to get and recommend a brand, shop near me can get a Charlton in for me this week and says it will fit fine without knowing these numbers, are these good chains, I only cut the odd dead tree up for my log burner. cheers, Liam.

I've never noticed mate, it has the original bar on it so may well have, i'll have a look in a minute if I can find the shed key, cheers.

hi, I bought a dolmar ps-410 last year in good condition and has been great but I now need a new chain and didn't relise there was as much selection as there is out there. I know I need 16 inch and the chain that is on it has 64 drive links but not sure about the size of the runners in the bar, can I just get any or do I need a specific size, cheers, Liam.