windswept

Hi Jase, neither forward or reverse working. Hydraulic pump belt is tight and new and alternator belt tight. It is working perfect for hours and its after been switched off and then on that it doesn't work. Doesn't happen all of the time but at the moment not working. I'll pass your advice on to the mechanic. The revs seem normal but what should they be at, good to know? We will run through what you said. The machine has just gone over a 1000 hours. Would it be possible that a valve could stick? Alan

Hi, Arbtrak 200 rollers not working intermittently. Checked everything. Solenoids , limit switches oil flow. Any ideas? Thanks

I normally use excel for the tree survey schedule after changing it to a print friendly format. The main report I just do in word. I figure if I could do the bulk of the excel information on site it would cut down the office time. I appreciate that there are probably easier ways but in my case I think I would be cutting the work load somewhat.

I like the look of the Samsung Active 2. Have always used Samsung so would be familiar. Also I tend to use excel for most reports so this could work. Anyone used these? Thanks for the feedback.

Thanks. Will look into that.

Hi there. Looking for some advice on how to collect tree data electronically. Mostly for BS5837 and standard tree reports such as health and risk. At the moment I record data on paper and type it up afterwards which is tedious. I seen a thread before on this but can't find it now. Thank you in advance.

Credit where it's due!

Great service from M Large Belfast. Richard and apprentice mechanic Nephin replaced carrier bearing and fly wheel on arbtrak 200, all covered on warrenty.Safe travel back to the North lads.[emoji3] [emoji3] [emoji106]

Great thanks

Hi Jase. Texted you this morning .I assume now that's a landline or I got the number wrong if you didn't get my message . Had to go to Germany and will call Friday when I'm back at the chipper. Sorry for the confusion.

Thanks Jase. Will do.

Sorry 300 rpm less than they normally would.

The revs are fairly constant just showing abut 300 rpm less than Burnsall both on idle and run. It is the older EHB box .

Hi. The feed rollers on my 1928 won't engage.also the computer display is showing a much lower rpm than normal. Engine revs still should the same. Could this be an electronic solinoid problem or worse the computer is busted? I've had the alternator tested and is fine. Advice will be much appreciated.

It's a Parker overcentre valve..I will ask my fitter to try a pressure test and see what that turns up. .