chainsaw surgeon
-
Posts
37 -
Joined
-
Last visited
Content Type
Profiles
Forums
Classifieds
Tip Site Directory
Blogs
Articles
News
Arborist Reviews
Arbtalk Knot Guide
Gallery
Store
Calendar
Freelancers directory
Everything posted by chainsaw surgeon
-
hi yes it whas the same one but have taken it off becouse i could not get it to run right it starts and runs fine but wont reach top revs ? i cant sell saws that are not 100" i may relist after having a look again later
-
problem with 023 starts and runs fine but wont reach top revs i have striped and cleaned carb but still wont rev right i have done a compresion test and it,s abought 90 psi is that enough it has a new piston and rings any one got any ideas
-
does any one know where i can buy a lorry load of hard wood in devon and how much sould i be paying or would it be better to try and buy a small woodland mostly for myself and maybe sell a few small loads off
-
Is the 395 a better saw then the stihl
-
Should i swap my 390 for a ms 650 .i use my saws just for my own logging and thought i would ask for your coments on both saws and what to look for on the stihl ,and what would the stihl be worth it is a 2007 model and very tidy , both saws have 28" bars look forward to your replies
-
What would you think the 3120 is worth it has a good 30" bar and new chain and is very tidy I whas told it could sale for 700 what do you think?
-
thanks for the help it whas the gap at the coil i adjusted it this morning and tried it out on some 24" oak and she never missed a beat, i have a husky 390 as well but i dont need two big saws, which saw would you say is the best for general logging for myself as i think i will sell one . also i have been looking at a stihl 066 would this be a better saw for logging or am i better staying with my huskys
-
Hi it has a black coil and the plug is light grey it has had a new piston and original pot carb striped and cleaned Sometimes the saw will backfire on full throttle and flames come out the exhaust I whas thinking that The coil is at fault as it seams to holding back any suggestions
-
hi does any one know if a 2005 3120 has a rev limiter the saw starts and ticks over fine and if you rev it up slowly it well rev to about 8000 rpm before starting to miss fire any help would be usefull
-
Hi the piston and pot failed because someone had put a peace of chain file in the inet manifold The saw runs fine up to half revs and seems to miss fire a bit
-
thanks i hope he can help
-
can anyone help with husky 3120 ,fitted new piston and pot, starts fine but revs at top end sounds like its running rich,can anyone tell me how to tune it as it has only one adjuster on carb
