Adal

Fit new plate assembly inlet and new inlet pipes both (rubber) when you try to start it there’s a fine mist of petrol comes out of the decompression valve (shut) and if you take the spark plug out the plug is wet if it does start it revs high if you push back in the choke it still reves high

Can anyone help me with the husqvarna k760 the plate assembly inlet has a crack in it so it does not fit flush, there are two kinds, one has wider style ports part No 574231802 that will not fit the cutter I have is pre 2013 has anyone know were I can find out what the part No is for the cutter one part No I have is 544352601 but it does not say the size

thank you, I have sent away for new intake pipes,

If you do not mind photos will help. yes the tube that comes from the top of the carb to the inlet manifold is on right

Hello adw how do you test to see if there is a gap between the manifold and the back of the cylinder, the impulse tube from tank to intake is fitted right, I will get a new rubber gasket for the air filter box, yes the piston was fitted right way the arrow faces the exhaust, the bore of the cylinder is 51 mm, the intake ports is 27 mm from centre to centre the cutter is pre 2013) thank you for your time helping me I will keep you posted if that is ok Alan

Hello all i hope you can help me Please. I have a husqvarna k760 that I have been trying to fix. At first i renewed carburettor diaphragm and gaskets still no luck I found that the compression was very low and the piston and cylinder had deep marks on the sides of the piston and walls of the cylinder so I renewed with new piston and cylinder head and gasket still will not start. Then I renewed the magneto and spark plug still no start I have had the carb in bits I have used carb cleaner on it still will not start. I have petrol from the tank to the primer. But if you take out the spark plug it is dry so is the cylinder. If I put petrol in the cylinder it will start.I bought a carburettor off e bay second hand sill no luck. I was told to take the carburettor to bits and remove the high and low needles then clean it with carb cleaner then blast it out with air but you need a tool to remove them that I have not got I just do not know what to do next at the moment I have a cutter on hire with the parts to fix this and hire is getting bad I hope some one can help me Please Alan