Sprocket and Clutch for a Jonsered 2051

[huskydusky]

Good afternoon all,

Looking for the above for my Jonsered 2051......they only seem available in the United States!!

 

Does anybody have any surplus to requirements.....or knows where I can purchase them from?

 

Is there other models that may be compatible that will fit the 2051?

 

thanks

[SawTroll]

2054 and 2055.

 

Those saws all use the common small 7-spline rims, so those should be easy to find anywhere.

[monkeymoreton]

I have a 7t 3/8 spur type and a second hand working clutch off a 510sp that should fit your saw no problems

 

Sent from my GT-I9300 using Tapatalk

[huskydusky]

I am currently running a 15" Micro-lite pro bar and .325 (95vpx) chain!

[SawTroll]

I am currently running a 15" Micro-lite pro bar and .325 (95vpx) chain!

 

Hardly the best set-up on that quite strong saw - but that is of course not the issue here.

 

Is it the clutch itself, or is it the drum that you need to replace?

Edited April 6, 2014 by SawTroll

[Neil-R]

Hi i can get the parts you need , PM me if interested

[huskydusky]

Hardly the best set-up on that quite strong saw - but that is of course not the issue here.

 

Is it the clutch itself, or is it the drum that you need to replace?

 

What bar and chain would you sugest?

 

Its the drum that will need replacing!

 

Thanks:001_smile:

[SawTroll]

Regular .325 (not narrow kerf). 21LPX would be my choise for chain (chisel chain).

 

Find a drum that takes rim sprockets, and try 7- and 8-pin ones.

 

2051 IPL

Edited April 7, 2014 by SawTroll