Clothing identification please

[mad matty]

I,ve had a couple of chains snap normally the chain catcher does the job....but have had one fly out forwards:scared1:

 

Due to sharpening chain past wear markers!!

oh well...Good luck

Cheers Matty:thumbup1:

[tigger24]

You need protective boots, trousers and a helmet with visor and ear defenders. But as importantly, you need to learn safe working practices.

 

Stay safe!

 

Thanks morten, i have all the above already and am already aware of assessing carefully before i start.

 

Didnt know i was cutting an old fence post that had a nail in it which gave me a bit of a startle ....... wont do that again

 

Also cutting wood on horse that spun upwards wasnt nice either

[tigger24]

I,ve had a couple of chains snap normally the chain catcher does the job....but have had one fly out forwards:scared1:

 

Due to sharpening chain past wear markers!!

oh well...Good luck

Cheers Matty:thumbup1:

 

Mad matty what happened when the chain flew out forwards>

 

Will keep an eye on the chain for wear/sharpening marks for sure

[mad matty]

Hi! Tigger24.....luckily when the chain flew forward it wrapped itself round a branch, was all my own fault trying to get to much life out of a knackered chain.

Cheers Matty:thumbup1:

[tigger24]

Glad you came to no harm Mad matty

 

help and advice much appreciated

 

oh just a quicky ............. what would have happened if the branch wasnt there? where would it have made contact?

[jrose]

I wouldn't say chains have a high risk of snapping - they can, but its not a common occurrence in my experience! Check chain for any signs of damage when you sharpen it and you should be fine.

 

You're more likely to get overheated, dehydrated and tired in a jacket, especially if you're not used to using a saw. This makes you more likely to lose concentration and make a mistake!

[mad matty]

dont panic its not a regular occurrence happened to me once in 22 years.......it would of just flew onward till it hit another branch.

best way is not to be scared of a chainsaw just treat it with respect...if that makes sense

Cheers Matty:thumbup1:

 

p.s. I take it your about to do your chainsaw course? what ever ppe is a must.

[tigger24]

I would say im a little warey ......... but not scared.

 

Im afraid im not about to do a course as im in France and i dont think they do them over here. Thats why i have been reading lots and lots on here and looking on the internet for quite a long time. Reading the good and the bad..

 

It is one of the reasons i was looking at getting a coat, just for extra protection, but they are soooo heavy.

[tigger24]

I wouldn't say chains have a high risk of snapping - they can, but its not a common occurrence in my experience! Check chain for any signs of damage when you sharpen it and you should be fine.

 

You're more likely to get overheated, dehydrated and tired in a jacket, especially if you're not used to using a saw. This makes you more likely to lose concentration and make a mistake!

 

I take your comments on board jrose thank you

 

as i just said to mad matty the coats are so heavy so i will give it a miss and just make sure i don everything else and check my chainsaw each time before i use it as you both have suggested.

 

Its a long drive to the hospital here..... 40 mins so wont be taking any chances

[mad matty]

What about trying to get hold of a copy of a nptc chainsaw course manual.....will have a dig around in the loft during the week see if I can find one, No promise's.

Ideally taking a course or learning from a skilled user is the best way.

Cheers Matty:thumbup1: