L200 u/j joint change any tips?

[blazer]

I need to change the centre propshaft bearing on my 03 L200, so I need to strip a U/J to access the bolt. It's one of these Jobs I haven't done before, so I would be very gratefully for a few tips.

 

Many thanks in advance:thumbup1:

[TimberCutterDartmoor]

Easier with ramps. Make sure you keep every part marked so that it's orientated correctly on re-assembly. Needle rollers in spider cups must be looked after! Get them lost or skewed oh my! Have a vice handy too...

[_tc]

Doesn't the centre bearing pass over he sliding joint? Ie: slide the uj complete out of the prop shaft?

I've not done an l200 one but done many on lorries etc.