Mega

Hi All, I have a Timberwolf 190 (not turbo) 2004 engine runs well everything seems to be good except the feed rollers won’t feed, although they run in reverse. I have checked the throttle cable to see if it is not going to full throttle but this is ok, I have checked the solenoids tried reversing them to see if one is not working but it is still the same, any ideas would be appreciated thank you

Morning all, I have Timberwolf 190, runs very well except when on a hill or at a angle, when on a hill or slight incline it cuts out as if it has no fuel, when I fill the tank to the very top it will then start again and seems to run with no issue, was wondering if anyone has come up with this issue before and has any idea how to fix it. thank you

Sorted now thank you, on the plus side I’ve cleaned all sensors and now know some valuable info if it happens again👍👍

Just been out disconnected the earth leads from the block and to the battery cleaned ( sanded down reconnected and boom all working, thanks so much for the info, wished I’d asked you all earlier would have saved myself a lot of stress and work,👍👍👍👍👍😀😀

Thanks for the reply, would this cause it to have zero power to the ignition?

Hi, I have Timberwolf 190 (not turbo) 2004 model. It has always been a bit temperamental to start but a couple of turns of the key normally get it running and runs well once going, in the past year I have changed the starter motor had a new key barrel fitted and always kept up with the servicing and general maintenance of the machine. yesterday I had small piece of wood stuck just before the feed rollers so I turned the machine off and removed the wood, I then tried to restart but it would not fire up, I’ve checked the sensors cleaned them all and refitted, I have tried the battery this has a full charge, occasionally when turning the key it give the clicking noise while the warm up light goes out but then just clicks and then goes dead and doesn’t seem to have any power at all ( the warm up light is not even lighting up now) I’ve tried tapping the starter motor to see if this release it but nothing, the battery is always connected to a altermeter so a to keep constant charge in the battery, at this moment I’m at a loss, I never waited for the engine to cool down before turning off but turned the revs down not sure if this is what has caused the issue, any advice would be greatly appreciated thanks in advance