Peachey J

Can u take the hopper of on a 530. If so is it the micro switch on the bottom of the hopper

Where the stop bar connects to the value block there is an black box with wires going into it with a nut on it. Undo the nut and give the middle of the black box a clean up with a file, also do the bit that comes out of the value block. You may feel it pulling itself back on like it's an magnet.

If not maybe re set the rollers at the circuit board. 3 black bottoms down the side and 2 lights around the middle. Rev the chipper flat out and hold top button bottom button together until the light flashes, then set the revs to where you want the stress to kick in and do bottom button middle button until the other light flashes. Then set the rev's back to flat out and the rollers should be spinning.

Hope this works or if I have got it wrong please correct me.

What sort of reach do you need. The firm I work for maybe interested in the job we run a few different heads.

I ve heard that NWR have brought 17 of them to be put round all the depots. They are very good on rail sites, I don't think they can be beaten!!!!!!

McConnell RoBo Mower, an excellentiece of kit. We hire them from Phil Livertons.

We had van done at Wharehorn Level Crossing. 1 x Ms200t, 1 x 261, 1 x pole saw, during the day.

Hi, I operate a 20 inch crane feed Bandit on tracks for Avondale Environmental Services which is available for hire. Or is she a bit on an over kill?....

Glad Stobart's think it's good chip. It was a interesting job, a nice location with helpful locals. It's a great machine and a pleasure to operate.