sharp edge

I have mannaged to fix this problem by making a gasket to sit behind the plate out of an old innertube and seems to have sorted it:biggrin:

Im usinga brand new stihl bar but have tryed two other stihl bars just to check that wasnt the problem. I did think that maybe it could be the oil so I left it inside over night and allas the same problem was there to greet me in the morning Think Im just going to take it to a dealership and get them to have a look at it. Cheers for all the advice

As far as I can tell that is how they have aways been when it was working. are the outlet hole and the hole in the plate suposed to be flush or is there suposed to be an overlap? Cheers Sam

Cheers dude Ill give that a go

Hello Just wondering if any ne can give me a bit of advice on this? At the moment my 361 isnt getting oil to the chain, I have cleaned out the pump and oil is flowing fine to the outlet but for some reason is flowing between the outlet and the plate that sits between the bar and the saw and just running out the bottom of the saw. The bar is clean so it is not that anything is blocked. Any thoughts would be much apreseated