PC tree

Nowt wrong with that, music aside

 

Lowering was decent. If you did your step cuts the other way around (top cut first, then bottom) it would prevent logs snapping prematurely and almost floating downstream

Lol ha thanks for that, it needed more gap too.....

I knew when I posted a vid I'd be hit with something, but I'm getting broad shoulders lol :-)))

Watched the first minute, and all I could think was - NO STUBS! And why would you ever compare yourself to Reg???

They're reduced further than what you see on the vid, so only main stems left. So the factory groundsmen can maintain them. And regards Reg I find his vids well edited and very professional.

Yours aren't too bad either..

nice work gota agree music pants...lol

Lol......... :-)

Please be gentle I'm not Reg Coates

Though constructive criticism is always good:thumbup:

Bit of shameless advertising there.....

Shocking ;-)

As said, the presets are just a starting point.

 

Be very careful, as a little knowledge is a dangerous thing.

My plan is to just check it and service it. Anyone know of a tuner on Derbyshire?

Provided the limiters are removed, yes.

 

Be aware that is just the starting point, fine tuning still remains!

Is that a "by experienced ear" thing????

So started out with so me 6" square dural mild steel plate and some 1 x 1/2" box section...

 

 

Not lucky enough to own a plasma cutter but a grinder and 6 1mm cutting disc do the job...

 

 

 

 

So the hard bits now done...

Assemble bits togeteher (bloody typical left out the bush the camera shot)

 

 

Sods law the gas always goes on the last weld you need to do...

 

 

So just swung some smoothrite on it hence the wet look and reflection...

 

 

1 Husqvarna crankcase splitter which cost £100 over the counter and covers 346 upwards saws.

Granted they can normally be split without it but its so much easier with one and no swearing or burnt fingers from heating up bearings....

And we shall nick name you Teflon:lol: just kiddin, looks good and if it works it works!

I've heard it can be caused through stress, periods of drought etc?? Just I've been told, seen a few beech trees with it, they look spectacular too!

Oh it's 2010 model if that makes a difference. Is that one full turn on both screws ??

No just checked !

Thanks for that Spud, are you local???

Is there a factory setting for it as I am giving it new plug and filters.. Just wondered if it would benefit a tune up and wondered how to go about it??

Cheers

Still or husky.. Had one, took it back as it was useless. Just my opinion :-))

Whats your channel name

carringtonp1977 there not brilliant mind!

Whats your channel name

Can't remember ill ave a look

Paul,

that should suit the Sycamore & Beech reductions:thumbup:.....well the second part anyway!

Yeah it was certainly greasy !!!

I can't see why you would want to pHilip, sounds like you used the correct technique.

Mmmmm okey dokey then...

Started this last week but was unable to finish it with the weather that's come in, so will post a picture when I'm done.

 

Please be gentle with the comments:001_smile:

Ah that's not worked!! I'll try again later:001_rolleyes:

Started this last week but was unable to finish it with the weather that's come in, so will post a picture when I'm done.

Please be gentle with the comments:001_smile:

Thanks for the advice guys, might be a bit embarrassing posting them on here with all the leg ends!! :-)

Next......

Got ya!

Anyone know how you get your vids more views,