Jump to content

C.J

Member
  • Content Count

    759
  • Joined

  • Last visited

Everything posted by C.J

  1. Mendip dialect (Jon) timber fly = wood fairy (log thief)
  2. C.J

    New MS391 not oiling chain!

    http://i59.photobucket.com/albums/g317/H2H_PHOTOS/MS%20250/390%20MM/001.jpg This is a 290 so very likely the same.
  3. C.J

    New MS391 not oiling chain!

    I was thinking this.Don't know about the 391,but on the 017/170 there is a coloured plastic plug in the end of the tube , that the oil pump is fitted.I can't find a picture ,but its a little orange piece of plastic on the chain side of the exhaust , and is visable on a clean saw without taking apart.
  4. C.J

    Recomend a small saw for hedglaying

    I have no problem with the dolly or using 1/4" pitch chain but I'm not sure about using a carving bar with no nose sprocket and a slack chain. Last winter I was using a MS170 with 3/8 x 1.1mm chain ( the same combination I have on my Kombi pruner ) and excellent for not grabbing. The 1/4 x 1.1mm chain should be even better and fully understand why people are recommending the MS150 or cordless saws.
  5. C.J

    Husky 390xp

    Coz a decent bar and chain must be 100 notes
  6. C.J

    Laurel hedge

    If there are no branches below 6 foot,I recommend you coppice next March /April and start again.It should grow 3-4 foot in the first year.
  7. C.J

    Best old tractor with high flow rate for splitter ?

    That's very good for a little 3 cylinder tractor - should be very economical. I have used my 1979 Ford 6600(which is supposed to produce 35 L/min)and would need to be at 16-1800 rpm to get an acceptable ram speed. More often I use it on my JD6400 at about 1200 rpm which is supposed to be 80 l/min.
  8. Heating oil is half the price it was during the winter 2012/13. Are your logs half the price ? No , they're not , because the price of cord is still high. What you need is some snow and ice to shift your logs.
  9. That was for 4000 Litres in South Wales on Wednesday. Fuel is at a 6 year low and still dropping.
  10. C.J

    Any recommends for wheeled strimmers?

    Did you buy that machine Beau? I collected a new self propelled machine from C.R.Willcocks today:001_smile:
  11. Only 86% self sufficient according to BBC breakfast yesterday. The problem is the exchange rate.The super markets say they can import it cheaper so understandably they want to pay less for U.K milk. Countries like France look after their farmers with higher subsidies,so the French farmers can afford to sell their milk cheaper. During Labour's reign subsidies were taken away from working farmers and given to land owners - not good if you are a tenant farmer.Also 20-25 % of subsidies now go to environmental schemes and the quangos that run them.
  12. C.J

    Kids & half term

    One on the fork and one on the rake.
  13. C.J

    Towing chipper with a ring hitch.

    The ring hitch on a over-run coupling is usually 40mm,whereas an agricultural pick up hitch ring is 50mm.
  14. C.J

    Grandfather rights for pesticide spraying

    The "grandfather rights" , sprayer training exemption , expires on 26 November 2015.
  15. C.J

    Greasing problem

    If its not been greased for some time , you may find the pin has worn badly ,creating a groove ,which the ram has sunk into ,preventing you from extracting the pin. I know you have written that the ram is slack, but it may not come out unless the ram is contracted enough to pull it out of the groove so you can remove the pin. Does that make sense ?
  16. C.J

    Problem cutting a large trunk into logs

    A Husky 24" is 84 drive links. Rob D already stocks 75JGX for Stihl saws,Hopefully He will soon have some 73JGX for 3/8 Huskies. A 20" (72 DL) husky bar is only 18" usable length , with dogs on. I often use a 24" with full skip on my 365 Special.
  17. C.J

    Show your tractors

    Looks like someone has modified the loader to take a chillton quick hitch.Make sure you have plenty of movement to crowd and tip a bucket.
  18. C.J

    Tipper ram

    Try parking looking up a steep hill, and raise and lower the trailer a few times.Hopefully the ram port will be at the highest point and the air will be expelled.
  19. C.J

    felling licence laws

    You can only sell 2 c.m
  20. C.J

    My Husky 346xp has a 41.7mm piston....??

    Something like this ? I appreciate the bottle is smaller , at the top , to improve accuracy but a small error in your petrol volume will result in a big error in the oil you add. Lets say you add 1% too much petrol,and then top up to the 50:1 mark. You will have 1010 ml of petrol and 10 ml of oil giving a ratio of 101:1:thumbdown:
  21. C.J

    Vintage Jonsered 621

    That explains it .My uncles old Jonsered used to pressurise the fuel tank and I never understood how it could happen
  22. C.J

    Husky 350

    The piston ring may be pinched or stuck and not sealing properly.
  23. C.J

    .404 196 link skip chain

    73JGX please.

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.