Jump to content

Log in or register to remove this advert

Greenmech cm202


Treeman123
 Share

Recommended Posts

Hi

 

Just wondering if you could help me please. I have just refurbished a cm202. The no stress control does not work. The red light stays red still at full revs. There is a sensor on the flywheel which light up but i cant see anything on the shaft that the sensor should be reading? I think a part is missing? Do greenmech have a some sort of diagram that i can follow to figure out why it wont work?

 

Also is there a measurement the rollers get to when they need to be replaced as the machine does not seem to break branches and drag them in very well, or is this just because they werent so good at this?

 

Any help would be great please

 

Regards

 

Joe

Link to comment
Share on other sites

Log in or register to remove this advert

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.