Jump to content

Log in or register to remove this advert

Go on then, What was your best Present??


Tommy_B
 Share

Recommended Posts

With a 2" its not much louder than an air rifle . With a 3" its a bit louder . Take the moderator off and its as loud as a 12 bore .  Its not so much of a bang as a loud sorta TING if you no what I mean .

Cheers Stubby, yep I get what ur saying, sounds like just the tool around the yard[emoji106]
  • Like 1
Link to comment
Share on other sites

Log in or register to remove this advert

16 minutes ago, Commando said:


Cheers Stubby, yep I get what ur saying, sounds like just the tool around the yardemoji106.png

I remember when I first got it I was not hitting things cleanly . So set up a pattern plate and found I was getting a cigar shaped pattern at a sort of 45 degree angle . On removing the moderator and looking down the barrel I could see that the muzzle brakes were all drilled from one side leaving internal burrs on the inside , and one side only , of the barrel . Careful work with a fine round file removed these and the pattern rounded up . I think it is bored  full or three quarters .  

Edited by Stubby
  • Like 1
Link to comment
Share on other sites

3 hours ago, djbobbins said:

a flip saw

A flip saw is handy for small joinery  .. but a sliding mitre is needed for construction timbers, I'd say that as a general tool a 305mm sliding mitre combined with the best table saw you can afford would be a good combination, I have some Metabo mid priced stuff that I'm not disappointed with from a non professional point of view. 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share


  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.