Jump to content

Log in or register to remove this advert

What's on your bench today?


spudulike

Recommended Posts

I had one in that had been in to a number of dealers who charged the owner for not fixing the problem.

Always an interesting one but on this one, I found the generator loop behind the flywheel was loose. 

The symptoms were it was rough running and sounded like it was four-stroking (running rich) but it seemed to pull reasonably OK.

You may find the screws that hold the generator in place are mullered and it may be a JB weld fix but worth checking this as it is mostly overlooked.

These machines did have issues with main bearings - difficult to tell from your vid TBH.

  • Like 1
Link to comment
Share on other sites

Log in or register to remove this advert

1 hour ago, peatff said:

It's 4 stroking, enriching the mixture for some reason. Try a reset on it and clean the filter out.

Filter all cleaned and blown through with compressor. Replaced plug as we have had these break down in the past. This is very early autotune so not sure what the reset procedure is with these. Thanks for the reply.

Edited by arbwork
Link to comment
Share on other sites

56 minutes ago, Cut4fun said:

How many use this tool for old school piston removals?

 

Guy in my FB group designed it. IMO better then the OEM one they had.

 

 

 

 

 

 

c37tool.jpg

c37tooll.jpg

Looks like it was designed by NASA, who on earth thought that was a good idea? Completely over top top

Link to comment
Share on other sites

14 hours ago, peatff said:

Who would spend on a special tool to get little end out then start a strip down with all that crap still on the saw ?

Ever heard of a parts saw. ;)  All parts getting stripped from saw to sell.  Some went on other saws.

So who gives a fly crap what gets down in there.  But if you want to volunteer to clean my parts saws be my guest.  😄

Link to comment
Share on other sites

17 hours ago, spudulike said:

I never like it when the top end comes off and the land around the cylinder base hasn't been pre cleaned, all that chip and oil falling in to the main bearings:(

So you clean all your parts saws.  What a laugh. Wasted time.

 

Saw getting stripped for parts.  😅

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.