Jump to content

Log in or register to remove this advert

What's on your bench today?


spudulike

Recommended Posts

Been lurking for a while, finally signed up today. Just finished reading this thread, all very interesting....learnt a lot from it.
 
I've just put a new p+c on my ms261, she runs well. I'm now thinking before I use it too much that i should find the original cause of the damage.
 
Any advice on where to start would be greatly appreciated.
 
Cheers
Harvey
Major air leak usually detectable to the discerning user. What spud says, and listen out for erratic idle or it real screaming
Link to comment
Share on other sites

Log in or register to remove this advert

52 minutes ago, spudulike said:

Old fuel oil mix, straight petrol, incorrect adjusted carb, air leak, carb issue etc... That's about it. Just tach it so it is 500 -1000rpm below maximum and all should be fine.

Cheers Spud!

 

Forgot to mention.....its mtronic ?

 

It's a second hand saw, so I'm hoping it's just had a bad mix in it at some point. Swapping it over to aspen now, so hopefully she'll be okay now?

Link to comment
Share on other sites

24 minutes ago, billpierce said:

Major air leak usually detectable to the discerning user. What spud says, and listen out for erratic idle or it real screaming

Ok thanks ?

 

I did an mtronic reset, and seems to be idling and revving out well now.

 

Hopefully it stays that way.

Link to comment
Share on other sites

18 hours ago, Heavy Oil Saw said:


Fit the new type fuel filter, has a higher micron rating and obviously stops more crud getting to the carb/solenoid. Think it has the orange body. From what I’ve read.

Ok, thanks for that. 

 

Do you know the part number, only one I can see at the minute is the standard black and white one.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.