Jump to content

Log in or register to remove this advert

Help with 346xp


YT23
 Share

Recommended Posts

Log in or register to remove this advert

5 hours ago, YT23 said:

image.png.a1b5da412207ba2fbaa75b9b9cde11c2.png

 

I will replace parts 1-6 with a new 21BPX chain and 15inch bar. 

 

That should keep me going till winter when stubby will port the saw for me.

Don't forget in rim sprockets there are small and large sized Rim sprockets(346 is small)Number 5 needs reg greasing.

To get clutch off something like a punch or smallish cold chisel theres the ones that end with a small flat tip or chisel with a blunt/flat on it.On face of clutch theres a recess says Off by it place chosen object in/around recess and a smart whack on it with hammer to the right/forward undoes it.

Often esp if not sure on history or if worn/bearing dry! to replace Bearing.Rim sprocket and Drum as a kit in one As often because need to remove clutch as outboard the bearing don't see much grease!

Link to comment
Share on other sites

6 hours ago, AngrySquirrel said:

Don't forget in rim sprockets there are small and large sized Rim sprockets(346 is small)Number 5 needs reg greasing.

To get clutch off something like a punch or smallish cold chisel theres the ones that end with a small flat tip or chisel with a blunt/flat on it.On face of clutch theres a recess says Off by it place chosen object in/around recess and a smart whack on it with hammer to the right/forward undoes it.

Often esp if not sure on history or if worn/bearing dry! to replace Bearing.Rim sprocket and Drum as a kit in one As often because need to remove clutch as outboard the bearing don't see much grease!

Does anything else need greasing besides number 5?

Link to comment
Share on other sites

11 minutes ago, YT23 said:

Does anything else need greasing besides number 5?

Maybe your Nuts?.Rake bar clean if using old one.in Sharpening kit there is a tool for it but something that will run down slot in bar will do as need to clean old saw dust n crap out of there plus can clean n grease sprocket on end of bar if has a G port?

I clean/rake out round end of groove and sprocket gap as bits get wedged in there moving sprocket back n forth till looks clear heavy oil in there helps bearing if no grease port.

 

to check bar specs re gauge n pitch should be stamped just outside where fixing point is.

clean air filter!

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share


  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.