Jump to content

Log in or register to remove this advert

ms200t help


tree79
 Share

Recommended Posts

Hi all

Just looking for a little help.

My ms200t struggles to hold full rev, it then dies at when at full rev.

It then doesn't start unless on half choke.

When I take the fuel Cap off there also a vacuum to.

 

 

I've clean the air filter, tank vent but still no better.

Any help would be great thank you.

 

 

Link to comment
Share on other sites

Log in or register to remove this advert

Doesn't sound like impulse,  it would most likely run like an absolute dog if it even ran at all. I'd pressure/ vacuum test the tank, it should hold pressure but leak down under vacuum. If that all checks out then it's time for a carb rebuild, as others have said most likely accelerator pump depending on the iteration of the c1q that you have.

Link to comment
Share on other sites

Sounds like the carb needs a full and proper rebuild - I am not just talking a few new rubber bits either! If the impulse had come off then the idle would be very fast and not good. The breather - if it has the dual fuel/breather fuel pipe, can be removed and a piece of pipe put on it and either pressure checked or just suck on it as the bishop said to the actress....but we digress;) 

Some depends on if the saws idle went loopy and someone has messed with the carb to accommodate it or if the saw just started bogging.

Worth checking the throttle and switch control shaft as if they are damaged, there will be little or no fast idle.

Link to comment
Share on other sites

  • 4 weeks later...
On 18/11/2017 at 17:45, tree79 said:

Thanks for you all help, will check the pulse pipe.

I did clean the tank vent, but you might be right it's not a vacuum. 

 

Will let you know my progress 

 

Thanks for your help

 

Tree

It's quite hard to determine whether those tank vents are clear or blocked sometimes. It only needs to be allowing less in than is being sucked out by the carb diaphragm! For their tiny price I'd just bin it any way along with the fuel filter and get new ones! Might also be one of the diaphragm in the carb - again pennies!

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  •  

  • Featured Adverts

About

Arbtalk.co.uk is a hub for the arboriculture industry in the UK.  
If you're just starting out and you need business, equipment, tech or training support you're in the right place.  If you've done it, made it, got a van load of oily t-shirts and have decided to give something back by sharing your knowledge or wisdom,  then you're welcome too.
If you would like to contribute to making this industry more effective and safe then welcome.
Just like a living tree, it'll always be a work in progress.
Please have a look around, sign up, share and contribute the best you have.

See you inside.

The Arbtalk Team

Follow us

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.