Bars and chains

[case mx270]

Right I ve got Oregon bars and chains ( I m a very part-time operator of a saw)are these a good choice or am I missing something bearing in mind I don't make a living cutting up wood .

[Stubby]

Right I ve got Oregon bars and chains ( I m a very part-time operator of a saw)are these a good choice or am I missing something bearing in mind I don't make a living cutting up wood .

 

Nothing wrong with those . I favor the Sugihare bars nowadays but always use Oregon before . Chains are good .

[mendiplogs]

Right I ve got Oregon bars and chains ( I m a very part-time operator of a saw)are these a good choice or am I missing something bearing in mind I don't make a living cutting up wood .

 

Hi CASE there ok ROB D best chap to get chains and bars off of thanks Jon

[Sawchip]

Right I ve got Oregon bars and chains ( I m a very part-time operator of a saw)are these a good choice or am I missing something bearing in mind I don't make a living cutting up wood .

 

Same as Stubby…Oregon is good stuff. I use there LPX chain in 3/8 and .325 sizes and there bars are better than the average for lasting iv found. Sugi is the mutts nuts though but you will pay a bit in the start..ok if you have one or two saws I guess.

Windsor bars and chain are also made in the same factory as Orogen i believe .. iv got there Windsor roll-top bars .

Stihl bars seem to be very decent as well as there oil O matic chain…Full chisel is my choice mostly and i tend to put Sthil bars on Sthil saws.

[TGB]

Nothing wrong with those . I favor the Sugihare bars nowadays but always use Oregon before . Chains are good .

 

 

That sums it up for me too.

[Pr04log]

I have used for years a good budget bar,chain no problems.

[Ironbark]

Not use the Sugi bars, but I rate Cannon bars.

[TheHungrySquirrel]

Only run sugi bars now after melting husky and oregon bars.