2101xp cylinder head conversion.

[Messerschmitt-Longboards]

Would any of the Wizards here be able to advise on possible cylinders that might fit this saw. I don't need one right now, but knowing my luck I will sometime in the future.

 

The OEM cylinders are seemingly rare as hens teeth.

 

I was wondering wether a 395xp cylinder would work but I've noticed it has the same bore, but a 2mm shorter stroke.

 

Any thoughts would be much appreciated.

 

 

Sent from my iPhone using Arbtalk

[adw]

Sorry mate you cannot fit a 395 cylinder, any cylinders that would have fitted are probably long gone 185/285/1100/2100.

[Stubby]

Would any of the Wizards here be able to advise on possible cylinders that might fit this saw. I don't need one right now, but knowing my luck I will sometime in the future.

 

The OEM cylinders are seemingly rare as hens teeth.

 

I was wondering wether a 395xp cylinder would work but I've noticed it has the same bore, but a 2mm shorter stroke.

 

Any thoughts would be much appreciated.

 

 

Sent from my iPhone using Arbtalk

 

Just use top quality oil ( Husqvarna XP or Red Line etc ) Make sure the carb is always adjusted correctly and it wont over rev . Keep all the potential air leeks at bay and it should keep going for a good while yet .

[adw]

Well said, the carb has a govenor so they did not normally over rev, always ran them on 25.1 mix they last for ever.

[Messerschmitt-Longboards]

Ok will do. Yeah been running 25:1 as per user manual. Hopefully I'm just worrying for no reason.

 

 

Sent from my iPhone using Arbtalk